Modular wall plates

Order form below.

Here is the rear view of a typical module. Notice that the cable entry is on underside. If you need the cable entry to be on the upperside you can invert the module and clip it into the wall plate bezel upside down. Note, however, that the markings will then be upside down.

You can download a brochure - click HERE to go to the download page

In general, the modular wall plate inserts have one cable per insert EXCEPT for the "quad" plates C13319 and C13897 which require two cables. The "diplex" and "triplex" plates contain filters which separate out the 2 or 3 signals that you are sending down one cable from your Loft Box or signal combiner.

PLEASE read important notes HERE about fitting cables to wall plates.

DIMENSIONS

Smaller modules extend approximately 15mm backwards from the rear of the face plate. Larger modules (e.g. C13319 and C13897) extend 22mm backwards.

Triplex plates can not have a TV DC connection because that would mix with the SAT DC feed (LNB power). However, it doesn't normally matter because a Loft Box feeds power to the Remote Extender. If you are not using a Loft Box, you will need to find an alternative way to insert the DC power feed if you are using one or more Remote Extenders ("magic eye").

Diplex plates (TV and Radio) pass power only through the TV connection.
Diplex plates (TV and SAT) pass power only through the SAT connection.
You can drill blanking plates to fit two '090-3078 Threaded "F" barrels'.

Please read important notes about colour matching etc. HERE

Wall plates and socket modules. Please note that these units require the deepest available box.

Please make a careful note of the part numbers, above, then use the form, below, to enter your quantities. Not all available items are in the photograph so please check the list below. Enter the quantity for each item. Leave blank if you want none. When your list is complete, click the "Add to Cart" button at the bottom of the list.

Where the Triax part is unavailable we may supply an alternative. Please note that the white plastic insert colour shades do not match the white plastic plate colour shades. There's nothing we can do about this other than be honest and tell you in advance!

By careful drilling, you can fit two of our 090-3078 Threaded "F" barrels into a C14084 (black) or C13166 (white) blank plate to create a twin "F" connector socket module. You can fit more into the larger blank plates. Some filing or cutting may be necessary.

090-3078 Threaded "F" barrel £0.29 Qty Nuts Qty free nuts 090-2824 Right angle "F" adapter £0.99 Qty Right angle F adapter is used where the cable goes straight up or down. Simply screw it on.

See page 7 for "F" cnnector plugs to suit cable.

Click on blue underlined part numbers, below, to see pictures of modules.